20% OFF shipping at laserhairremovaltc.com on orders over $79 + up to 10% OFF products
laserhairremovaltc.com
home > STATOR + CNC MOSFET KIT GSXR600/750 06-19 (RMS900-107319) > STATOR + CNC MOSFET KIT GSXR600/750 06-19 (RMS900-107319)
download picture
STATOR + CNC MOSFET KIT GSXR600/750 06-19 (RMS900-107319)Brand new aftermarket Stator + Crankcase Cover Gasket + Mosfet Voltage Regulator Kit Direct replacement to your original unit Plug and play, direct fit, easy installation All products shipped are tested We have even included the opposite connector (main harness side) as we know these are often melted corroded defective and a major cause of repetitive electrical issues. All item pictures are accurate; if in doubt do not hesitate to compare our item to
Shopping security

Shopping security

Each payment you make on thelockerguy is secured with strict SSL encryption and PCI DSS data protection protocols

Brand new aftermarket Stator + Crankcase Cover Gasket + Mosfet Voltage Regulator Kit

  • Direct replacement to your original unit
  • Plug-and-play, direct fit, easy installation
  • All products shipped are tested

We have even included the opposite connector (main harness side) as we know these are often melted / corroded / defective and a major cause of repetitive electrical issues.

All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Stator:

  • Highest-grade lamination materials
  • Highest-grade copper windings, resistant to 200 degrees Celsius.
  • Stator crankcase cover gasket included
  • Connector included
  • Rubber grommet included

Brand new RMSTATOR Red Machined Aluminum Mosfet Regulator

Our new RMSTATOR machined aluminum Mosfet voltage regulator is a great upgrade for heat dissipation in any powersports charging system. After 10 minutes of use, our billet aluminum heatsink runs cooler by 33% than standard cast regulator housings. Our new RMSTATOR red regulator, equipped with the renowned Mosfet regulation technology, is an added value to any three- phase permanent magnet charging system.

STOP BURNING YOUR REGULATOR RECTIFIER!

It is time to update or replace your voltage regulator with the advanced MOSFET type.

It runs cooler than all OEM diode style regulators. In addition, this rectifier has overheat protection, rather than burn up, it will simply turn off for a while and cool off.

  • The quality exceeds the OEM equipment
  • Improved heat sink and charging capabilities
  • Higher grade of electric components

Why use Mosfet Enhanced technology?

  • Runs cooler: Runs much cooler than the traditional Shunt voltage regulator rectifier.
  • Saves gas: Less load on the stator, less work, less fuel is used and you save.
  • Regulated energy: The power charging your battery is steadier and smooth.
  • Extended battery life: Extends the battery’s life and cold cranking capacity.
  • More engine power: Removes stator load resulting in more engine power.
  • Optimized power: Optimize power delivery by switching the stator coils on or off.

With Enhanced Technology Design

This product is an advanced design that lowers operating temperatures for extended longevity and better performance than the OEM part.

Specifications:

  • Dim ensions Stator:
    • Interior diameter: 38 mm
    • Exterior diameter: 107 mm
    • Thickness: 12 mm
    • Length of wires stator to grommet: 160 mm
    • Length of wires grommet to plug: 330 mm
  • Other specifications:
    • Number of wires: 3
    • Number of plugs: 1
    • Number of pins: 3
  • Wire-to-wire resistance:
    • Alternator: Yellow to Yellow = 0.5 ohms +/-20%
  • Regulator dimension:
    • Width: 92 mm
    • Length: 92 mm
    • Height: 30 mm
    • Fixation holes center to center: 75 mm
    • Wires length: 300 mm
  • Other specifications:
    • Number of plugs: 2
    • Number of pins: 7
    • Number of wires: 7
    • Minimum Charging Voltage: 14.5 V +/- 0.5 V
    • Maximum Charging Current: 50 A / 500 W
    • Open Circuit Voltage: < 15 V
    • Operation Temperature: -20° C to 85° C

Note: Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.

STATOR + CNC MOSFET KIT GSXR600/750 06-19 (RMS900-107319)

Item no : 95318188043
sold recently : Login >>
US$ 238.00
Pay in 4 interest-free payments of $59.50 Learn more
Min. order: 1piece

Shipping Estimate
USA
  • USA
  • CAN

Ships within 48 hours · Estimated delivery Jun 22 - Jun 27

Enjoy 20% off shipping

US$ 238.00

1-11

US$ 214.20

12-35

US$ 166.60

36-59

US$ 142.80

60+

US$40

Get now

Sign up to your membership to get coupons up to

15%

Get now

Opportunity to enjoy order discount up to 15% off

Please add the products
Shipping Notes
  • Free Standard Shipping on $100+ Orders to the USA.
  • Except Preorder products are shipped in 48 hours.
  • Delivery to the USA:
  1. Standard Shipping : 3-10 business days
  • If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
  • We offer a 30-day return/exchange service after receiving.
  • Final sale items are not eligible for returns or exchanges.
  • To process your return/exchange, please contact us at [email protected]
  • Please click here for more details>>> Return & Exchange Policy

Discover Niche Categories That Outsell

Top-Converting Item to Boost Your Average Order

recommand products

La Danza III
La Danza III

US$ 4997.50

Min. order: 1 piece

4.2 (243 reviews)

Sold : Login>>

Smoke Ring
Smoke Ring

US$ 1375.00

Min. order: 1 piece

4.3 (287 reviews)

Sold : Login>>

Related Searches